Step 1: Lift the eyelash band from the packaging.
Using your tweezers (or fingers), slowly and gently remove the eyelashes from its packaging. Do not tug on the fur, only handle from the cotton band. Be careful & patient!
Step 2: Measure & Trim
Measure the eyelashes by putting them closely on your natural lash line. The falsies should be attached where your lashes start and end. Don't put it too close to the tear duct. Using the scissors, cut where it should start and end. Remember, cutting less is better than cutting too much - because you can always cut more.
Step 3: Apply lash adhesive
Apply lash glue along the entire cotton band and wait 30 seconds for glue to become sticky. We recommend our latex free "Honey Grail Adhesive" sold on our website. Now, apply the lashes to base of your natural lash line. Position and hold for a few seconds for it to dry.
Tips for cleaning the adhesive from your lashes.
Be extremely careful when removing adhesive off eyelashes! To clean the lash band, you will need flat tweezers to help you remove the adhesive from the lashes. While firmly gripping on the lash fur with your thumb and forefinger close to the band, use the tweezers to gently pull of sections of glue adhered to the lash band.
For best results, clean off the adhesive on lashes after each use.
DO NOT apply mascara on the false lashes!
DO NOT soak in water or any other liquid.
DO NOT apply mascara on the false lashes!
DO NOT soak in water or any other liquid.